Camel Dust Calibrated Patio Pack A HCamCalHCNPPA-22
Camel Dust Calibrated Patio Pack A
Total SQM Coverage:
Camel Dust Paving is probably our most colourful paving material. It is quarried from our own family-owned quarries in India. There are pinks, purples, beiges and neutral tones in this paving. Between 10 and 40 per cent of the paving will have a beautiful tiger stripe on the surface of the stone. We stock it in a wide range of sizes. 30x30, 60x30, 60x60, 60x90 and also two different patio pack sizes. All of our Camel Dust Paving is calibrated, this means that it is all the same thickness and can be laid on a screed - trust us when we tell you that this will make your installers job alot easier. This is one material which can brighten up and enhance the look of any drab garden. In terms of maintenace all that is required is to powerwash the stone once a year using our Sandstone Cleaner and it will come up looking like new.
|Paving Size||300x290mmx16pc / 600x290mmx16pc /600x600mmx16/10.08m|
|Paving Sold By||M2|
|Tiles per Box||48|
|SQM per Box||10.08|
|Finish||Handcut Edges, Natural Surface|
Write Your Own Review
How To Lay Paving Slabs Step one> The area to be paved must dugout to at least 200mm in depth. Following this the area should then be back filled with 150mm sand/gravel 6 parts to one part cement, which is then to be compacted to 100mm. Step two> After the complete preparation of the area to be paved is complete, the laying can start. The mortar bed must be prepared for each slab individually, dependant on the depth/thickness that/each slab. A semi-dry mortar mix using 4 parts sand to 1 part cement is the necessary mix for the mortar bed. This ratio must be adhered to for natural stone to ensure it to have adequate support for the slab. Step three> When installing slabs that will have mortar joints, ensure the receiving joints of the already laid slab are lightly lathered. As when the adjoining slab is placed it creates a strong joint, which can be further strengthened during the pointing process. Lathering the mortar will also help keep a consistent joint profile throughout the area. When the slab is in place, it can be secured by tapping it down with a rubber mallet. Constantly throughout this laying process you must check the levels to ensure uniformity. Step four> Pointing (filling in the gaps) stage. With a wet mortar mix with a ratio of 4>1 building sand>cement, make sure that all the gaps between the slabs are completely filled. This is an important step to create a strong paving area, where there is gap there can be weakness, removing gaps strengthens the area. While pointing be careful not to use an excess as removing can be difficult.