Cement Backed Cladding Yellow 60x15cm HP014-6015
|SQM per Box||0.36|
|Pieces Per Box||4|
How to Install Cement-Backed Cladding
Installation of our cement-backed stone cladding is very simple. However, if you need any further advice, please feel free to contact us.
We highly recommend CT1 Power Grab and Bond for our cladding installations. This specialist stone adhesive will work on almost any surface including wood, plaster board, backer board, metal, brick and concrete. However, any good-quality rapid-set tile adhesive should be work just fine as well.
Put two separate beads of adhesive lengthways on the back of the cladding piece and press it firmly against the wall. Initial grab will take 10-15 minutes during which time you may need to support the cladding panel with a piece of wood or similar. Most adhesives will be fully cured within 24 hours, however some adhesives may vary, so please check first. Be warned, once the adhesive has completely cured it is impossible to remove the cladding from the wall.
For internal corners, simply cut the cladding to form a straight edge.
For external corners, we supply special corner pieces. Each cement-backed corner piece is 150mm high, so in order to calculate how many corner pieces you require, measure the height of the wall and divide it by 150mm. For example if you were installing this product on a standard 2.5m high wall inside a house, you would need 17 corner pieces.