Kandla Grey Sandstone Hand-Cut Calibrated Paving Patio Pack B / 15.12m2

In stock
Kandla Grey Sandstone Hand-Cut Calibrated Paving Patio Pack B / 15.12m2
100% of 100
€332.53 /unit
€21.99 /m2
FREE Cut Sample
best price promise
free samples no delivery charge
free delivery on orders over €300
Need help? Call Us on (01) 486 6330

The Kandla Grey paving pack contains mixed sizes, hand-calibrated and in soft shades of grey. It is a paving option for those who value contemporary styling without compromising on character. The surface finish is riven as a result of the natural block splitting along its line of cleavage, which creates stunning natural texture.

This patio pack is made up of 3 different sizes 60x30,60x60 and 60x90.
Material Sandstone
Colour Grey
Size 600x300mm (14pcs) + 600x600mm (14pcs) + 900x600mm (14pcs) / 15.12m2 / 22mm thick
Finish Calibrated
Edge Style Hand-Cut
Suitability Patio
Brand Tile Merchant
Quantity Per Box 42
M² Per box 15.12
Write Your Own Review
You're reviewing:Kandla Grey Sandstone Hand-Cut Calibrated Paving Patio Pack B / 15.12m2
Your Rating

How To Lay Paving Slabs

Step one>

The area to be paved must dugout to at least 200mm in depth. Following this the area should then be back filled with 150mm sand/gravel 6 parts to one part cement, which is then to be compacted to 100mm.

Step two>

After the complete preparation of the area to be paved is complete, the laying can start. The mortar bed must be prepared for each slab individually, dependant on the depth/thickness that/each slab. A semi-dry mortar mix using 4 parts sand to 1 part cement is the necessary mix for the mortar bed. This ratio must be adhered to for natural stone to ensure it to have adequate support for the slab.

Step three>

When installing slabs that will have mortar joints, ensure the receiving joints of the already laid slab are lightly lathered. As when the adjoining slab is placed it creates a strong joint, which can be further strengthened during the pointing process. Lathering the mortar will also help keep a consistent joint profile throughout the area. When the slab is in place, it can be secured by tapping it down with a rubber mallet. Constantly throughout this laying process you must check the levels to ensure uniformity.

Step four> Pointing (filling in the gaps) stage. With a wet mortar mix with a ratio of 4>1 building sand>cement, make sure that all the gaps between the slabs are completely filled. This is an important step to create a strong paving area, where there is gap there can be weakness, removing gaps strengthens the area. While pointing be careful not to use an excess as removing can be difficult.