Kota Green Patio Pack A Large HKotaGreenHCNDPAVPPA
Total SQM Coverage:
Kota Green is a beautiful natural paving stone which is quarried in our own family owned quarries in India. It has a beautiful green tone which will suit the discerning customer who is looking to give their patio area the wow factor. It is a Limestone and is amongst the highest-grade of stones which we sell, very hard wearing, naturally slip-resistant and also with little to no colour fading from direct sunlight. Because of these superior qualities it is also very suitable for busy commercial areas such as highly-trafficked walk-ways, outdoor bar areas and feature/show-piece outdoor areas in hotels. We stock this material in a range of different sizes to suit almost any application including 30x30, 60x30, 60x60, 60x90 and patio packs.
|Paving Size||300x290 x 32pcs / 600x290 x 32pcs / 600x600 x 32pcs|
|Paving Sold By||M2|
|Tiles per Box||96|
|SQM per Box||20.16|
|Finish||Natural Surface, Handcut edges|
Write Your Own Review
How To Lay Paving Slabs Step one> The area to be paved must dugout to at least 200mm in depth. Following this the area should then be back filled with 150mm sand/gravel 6 parts to one part cement, which is then to be compacted to 100mm. Step two> After the complete preparation of the area to be paved is complete, the laying can start. The mortar bed must be prepared for each slab individually, dependant on the depth/thickness that/each slab. A semi-dry mortar mix using 4 parts sand to 1 part cement is the necessary mix for the mortar bed. This ratio must be adhered to for natural stone to ensure it to have adequate support for the slab. Step three> When installing slabs that will have mortar joints, ensure the receiving joints of the already laid slab are lightly lathered. As when the adjoining slab is placed it creates a strong joint, which can be further strengthened during the pointing process. Lathering the mortar will also help keep a consistent joint profile throughout the area. When the slab is in place, it can be secured by tapping it down with a rubber mallet. Constantly throughout this laying process you must check the levels to ensure uniformity. Step four> Pointing (filling in the gaps) stage. With a wet mortar mix with a ratio of 4>1 building sand>cement, make sure that all the gaps between the slabs are completely filled. This is an important step to create a strong paving area, where there is gap there can be weakness, removing gaps strengthens the area. While pointing be careful not to use an excess as removing can be difficult.