PRICE GUARANTEE

WE'LL MATCH & BEAT THE PRICE

FREE SUPPORT

OUR EXPERTS ARE READY TO HELP

FREE DELIVERY

ON ALL ORDERS OVER £300*

95% OF PRODUCTS IN STOCK

HUGE WAREHOUSE READY TO DISPATCH

Kota Grey Limestone Patio Pack B HKotaGreyHCNPAVPPB

Rating:
100% of 100
Kota Grey Limestone Patio Pack B
€482.21 price/unit
€32.47 price/m2
Loading...
Kota Grey Limestone is a beautiful natural limestone which we source from our own family-owned quarries in India. It is a light to mid-grey in colour and there is very little colour variation between the different slabs. If you are looking for a cool, clean and modern look to your outdoor area or patio project this could be the stone for you. Due to its natural anti-slip properties, lower water absorption and clean aesthetic this stone has also been used in commercial applications throughout the country. From hotel walkways to outdoor areas in bars to seated outdoor terraces this stone has been used for almost all applications and areas. It is available in 30x30, 60x30, 60x60, 60x90 and patio packs.
More Information
Colour Grey
Brand N/A
Paving Size 300x290mm x9pcs/600x290 x13pcs/600x600 x13pcs /600x900 x13pcs/14.85m
Paving Sold By M2
Tiles per Box 48
SQM per Box 14.85
Paving Range N/A
Range Limestone Paving
Finish Natural Surface, Handcut edges
Material Limestone
Suitability Patio
Height N/A
Depth N/A
Write Your Own Review
You're reviewing:Kota Grey Limestone Patio Pack B HKotaGreyHCNPAVPPB
Your Rating
How To Lay Paving Slabs Step one> The area to be paved must dugout to at least 200mm in depth. Following this the area should then be back filled with 150mm sand/gravel 6 parts to one part cement, which is then to be compacted to 100mm. Step two> After the complete preparation of the area to be paved is complete, the laying can start. The mortar bed must be prepared for each slab individually, dependant on the depth/thickness that/each slab. A semi-dry mortar mix using 4 parts sand to 1 part cement is the necessary mix for the mortar bed. This ratio must be adhered to for natural stone to ensure it to have adequate support for the slab. Step three> When installing slabs that will have mortar joints, ensure the receiving joints of the already laid slab are lightly lathered. As when the adjoining slab is placed it creates a strong joint, which can be further strengthened during the pointing process. Lathering the mortar will also help keep a consistent joint profile throughout the area. When the slab is in place, it can be secured by tapping it down with a rubber mallet. Constantly throughout this laying process you must check the levels to ensure uniformity. Step four> Pointing (filling in the gaps) stage. With a wet mortar mix with a ratio of 4>1 building sand>cement, make sure that all the gaps between the slabs are completely filled. This is an important step to create a strong paving area, where there is gap there can be weakness, removing gaps strengthens the area. While pointing be careful not to use an excess as removing can be difficult.