Multistone Grey Matt Porcelain 60x60cm TMUGR-6060

100% of 100
Multistone Grey Matt Porcelain 60x60cm
€10.80 price/unit
€30.00 price/m2
This is a 60x60 grey coloured matt porcelain tile which is suitable for use in Kitchens and living areas. The base colour of this tile is grey and there is a nice white/light grey veining on the tile. Also available in 60x30 this tile can brighten up any drab area in your home and give you the finish you have always wanted. What are you waiting for - order a sample online today, with our price match guarantee you can rest assured that you are getting the best deal possible.
More Information
Colour Grey
Depth 10
Finish Glazed
Material Porcelain
SQM per Box 1.44
Pieces Per Box 4
Material Porcelain
Size 600x600x10mm
Sold By M2
Range Glazed Porcelain
Suitability Floor
Brand Tile Merchant
Write Your Own Review
You're reviewing:Multistone Grey Matt Porcelain 60x60cm TMUGR-6060
Your Rating

How To Tile A Floor>

Step one>

You cannot tile an area without knowing how many tiles you will need. So measure the area precisely. Always purchase 10 Percent more tiles than you need for the job to avoid any issues if accidents occur. After you purchase your tiles and before installing them, check that the tiles are correct colour and from the same batch.

Step two>

Prep. Clean the floor of all dust and debris. If check with a spirit level that area is flat. Use a levelling compound to level out floor. Choose pattern for your tiles. Traditional grid is the most popular - which is simply one tile beside each other and the next row linking up in the same pattern and repeated throughout.

Step three> Symmetry. Find the centre of your floor. Mark the centre by two lines converging at the centre point. Start tiling from here.

Step four> Adhesive. Mix rapid set adhesive to packet instructions. Spread your adhesive (mix to pack instructions) thinly but scaling up the heavier the tiles are. Spread adhesive with a tiling trowel at a 45 degree angle with a medium level of pressure. Spread in small sections at a time.

Step five> Down they go. Place the first tile carefully in the centre of the floor that you have marked previously. Press the tile into the adhesive with a medium amount of force/pressure to ensure tile is pressed sufficiently into adhesive.

Step six> Keep going. Keep going along the floor in the pattern that you have chosen. Use spacers in between each tile to keep a uniformity of grout lines that will follow. Remove any excess adhesive instantly as you go with a damp cloth.

Step seven> Edges. Around the edges of your floor you may encounter areas that tiles will need to be cut down to size. Measure up before cutting. Cut your tiles with extreme care and precision.

Step eight. Grout. Mix the grout to packet instructions. Ensure the grout colour is correct. Use a grout float to spread the grout across the whole surface of the floor, while doing this the cracks will fill and secure the floor. Wait 30 minutes before proceeding to next step.

Step ten. Nearly there. Clean off excess grout from the surface of the tiles with a large sponge soaked in soapy water. Wait 12 hours before applying any pressure on the surface of the floor.