Light up your outdoor space with some vibrant sand colour garden tiles. Luna Sand bright ivory tile that is a wonderful antidote to drab Irish weather in the weather and a fab attention grabber during sunny spells.
20mm Porcelain paving has changed the Irish patio landscape to its array of choice and added supercharged characteristics. Anti-slip, anti-frost, super strong and very long lasting, 20mm porcelain was created to be the perfect patio slab and it delivers.
Order garden slabs online now. We deliver outdoor porcelain to across Ireland - so if you need a driveway slab in Donegal, or patio area in Douglas or a bbq area in Dundrum, we can deliver to you!
|Quantity Per Box||4.000000|
|M² Per box||0.720000|
|Weight per m² (kg)||24.000000|
|Greenogue Warehouse Stock||192.12/M2|
How To Tile A Floor:
You cannot tile an area without knowing how many tiles you will need. So measure the area precisely. Always purchase 10% more tiles than you need for the job to avoid any issues if accidents occur. After you purchase your tiles and before installing them, check that the tiles are correct colour and from the same batch.Step two:
Prep. Clean the floor of all dust and debris. If check with a spirit level that area is flat. Use a levelling compound to level out floor. Choose pattern for your tiles. Traditional grid is the most popular - which is simply one tile beside each other and the next row linking up in the same pattern and repeated throughout.
Step three: Symmetry. Find the centre of your floor. Mark the centre by two lines converging at the centre point. Start tiling from here.
Step four: Adhesive. Mix rapid set adhesive to packet instructions. Spread your adhesive (mix to pack instructions) thinly but scaling up the heavier the tiles are. Spread adhesive with a tiling trowel at a 45 degree angle with a medium level of pressure. Spread in small sections at a time.
Step five: Down they go. Place the first tile carefully in the centre of the floor that you have marked previously. Press the tile into the adhesive with a medium amount of force/pressure to ensure tile is pressed sufficiently into adhesive.
Step six: Keep going. Keep going along the floor in the pattern that you have chosen. Use spacers in between each tile to keep a uniformity of grout lines that will follow. Remove any excess adhesive instantly as you go with a damp cloth.
Step seven: Edges. Around the edges of your floor you may encounter areas that tiles will need to be cut down to size. Measure up before cutting. Cut your tiles with extreme care and precision.
Step eight. Grout. Mix the grout to packet instructions. Ensure the grout colour is correct. Use a grout float to spread the grout across the whole surface of the floor, while doing this the cracks will fill and secure the floor. Wait 30 minutes before proceeding to next step.
Step ten. Nearly there. Clean off excess grout from the surface of the tiles with a large sponge soaked in soapy water. Wait 12 hours before applying any pressure on the surface of the floor.