Black Limestone Paving 60x90cm HBlacklimeHCNPAV6090

Rating:
100% of 100
Black Limestone Paving 60x90cm
€15.78 price/unit
€29.22 price/m2
Loading...
This smooth Indian Limestone is full of natural beauty. The handsome black hue and the dense Limestone combine to create a fantastic natural stone product. Add ambience to your outdoor environment and an instant design feature with this stunning black Natural Stone paving slab. Hand Cut, which leaves the slab with a chic beveled edge. Available in a range of sizes. A fantastic way to embellish your patio would be to add a Black Limestone Patio Circle and a Handcut Black Limestone Kerb.
More Information
Colour Black
Brand Tile Merchant
Paving Size 600x900x25/35mm
Depth 30
Paving Sold By M2
Pieces Per Box 1
SQM per Box 0.54
Range -
Finish Handcut Edges, Natural Surface
Material Limestone
Suitability Patio
Write Your Own Review
You're reviewing:Black Limestone Paving 60x90cm HBlacklimeHCNPAV6090
Your Rating

How To Lay Paving Slabs

Step one>

The area to be paved must dugout to at least 200mm in depth. Following this the area should then be back filled with 150mm sand/gravel 6 parts to one part cement, which is then to be compacted to 100mm.

Step two>

After the complete preparation of the area to be paved is complete, the laying can start. The mortar bed must be prepared for each slab individually, dependant on the depth/thickness that/each slab. A semi-dry mortar mix using 4 parts sand to 1 part cement is the necessary mix for the mortar bed. This ratio must be adhered to for natural stone to ensure it to have adequate support for the slab.

Step three>

When installing slabs that will have mortar joints, ensure the receiving joints of the already laid slab are lightly lathered. As when the adjoining slab is placed it creates a strong joint, which can be further strengthened during the pointing process. Lathering the mortar will also help keep a consistent joint profile throughout the area. When the slab is in place, it can be secured by tapping it down with a rubber mallet. Constantly throughout this laying process you must check the levels to ensure uniformity.

Step four> Pointing (filling in the gaps) stage. With a wet mortar mix with a ratio of 4>1 building sand>cement, make sure that all the gaps between the slabs are completely filled. This is an important step to create a strong paving area, where there is gap there can be weakness, removing gaps strengthens the area. While pointing be careful not to use an excess as removing can be difficult.